Use these simple to use clip-on fuse replacements for 3AG/3AB and M205 fuses.

As an electrician, you've probably been through this before.

You get called to a failed piece of equipment and localise the fault down to a particular circuit board.

A bit of testing and you realise the soldered-in-place fuse on the circuit board has blown.

To change these types of fuses usually requires removing the circuit board and it's associated wiring from the panel that it's mounted on, getting your soldering iron out and carefully trying to remove the old fuse without damaging the PCB.

THEN you have to see if you have that type of fuse of that value in your toolbox.

You can put all that behind you with Re-fuse-it in three simple steps:

And that's it!

Obviously, take all precautions regarding power isolation and other safety steps before carrying out this sort of repair.

So - get some in your toolbox now, ready for the next time you come across those pesky, soldered-in fuses!

FACT! 3AG fuses are 1/4" or 6mm in diameter. M205 are 5mm in diameter. So the clips will fit any other fuses of these approximate diameters.

Re-Fuse-It is available for £10.55 for a pack of 10 including postage and V.A.T.

Questions? Contact us HERE.